Customer Review

• 

  Bailey

  4.0 out of 5 stars Cheap enough and gets the job done pretty nice

  Reviewed in Canada on July 4, 2020

  Verified Purchase

  Used it for tie rods, ball joints, upper control arms, lower control arms, it makes seperating a ball joint (controll arm or tie rod whatever type of joint) pretty ok. I don't think these are impact rated but i didn't care at all so i gave it the beans with my 1/2 milwaukee midtorque and the little pin that holds both pieces together snapped. Probably just gonna chuck a bolt in it and nut i don't care it was cheap and got the job done. It still works, the pin is just long enough to still engage it so i will use it. It's just meant to put pressure on the joint then give it a few hits where the joint goes into the knuckle or wherever and it should just fly right out. I was lazy and the tool broke, if you care use hand tools.

  Helpful

  Report Permalink

  Showing 0 comments

  There was a problem loading comments right now. Please try again later.

  ---