Colle rapidement
Brand | REHOUPTY |
Specific uses for product | Wallpaper Adhesive |
Material | Vegetable Cellulose |
Compatible material | Fabric |
Item form | Paste |
CLEAN THE SURFACES | Thoroughly clean and dry the surface to be wallpapered. Remove any residue, dirt and old wallpaper. Repair any damage and ensure the surface is smooth. |
PRIME THE WALLS | We recommend priming the wall with a primer or base film adhesive before using the product. Priming the wall surface increases adhesion, improves the adhesion and durability of subsequent wallpapers. |
CUT THE WALLPAPER | Before applying the wallpaper adhesive, first measure the size of the wallpaper to be pasted with a tape measure, and then cut the wallpaper into long strips with a cutting tool to make it easier to paste. |
APPLY ADHESIVE AND STICK | Apply a thin layer of REHOUPTY WALLPAPER ADHESIVE to the back of the wallpaper with a tool such as a squeegee or roller brush. Start from the center of the wallpaper and work towards the edges to create an even layer of adhesive, making sure there is enough adhesive in the joints. Once the wallpaper is fully adhered, it is time to attach the wallpaper to the wall. |
NOTE | Using a felt squeegee will minimize scratches. Take care to level the wallpaper and remove any excess adhesive when using it. |
EVENLY APPLY | Apply wallpaper glue evenly, tightly, without leakage, pay attention not to wrap the edges, pile up or pile up, so as not to dirty wallpaper. This helps to ensure that the wallpaper is pasted flat and avoid bubbles or hollow drums. |
WALL PREPARATION | The wall should be clean, flat and dry. The preferred time to paste wallpaper is when the weather is sunny, because this will ensure that the wall is dry, to avoid the paste problems caused by wet walls. When laying wallpaper, the air humidity in the house shall not be greater than 85%. |
WINTER SPECIAL TREATMENT | Winter is recommended to use glue thinly applied way to shorten the drying time, effectively avoid wallpaper edge warping, cracking and other phenomena. |
TOOLS | When painting the glue, it is best to use special tools, such as squeegee, so that the glue evenly coated in the wall. |
USE METHOD | You can apply the glue on the wallpaper and then put the wallpaper on the wall, or directly apply the glue on the wall and then paste the right size of wallpaper, it's up to you what you think will work better without wasting wallpaper and glue. |
REPLACEMENT OF WALLPAPER | If you need to replace the wallpaper after using this product, apply water or wallpaper stripper to the wallpaper and wait a few minutes to allow the wallpaper to soak in completely. Use a squeegee to begin stripping the wallpaper from top to bottom. |
PAINT THICKNESS | It is recommended that the thickness of the wallpaper glue is about 1 mm. If you apply too much wallpaper glue, when scraping the surface of the wallpaper, the glue will be squeezed and through the wallpaper, which will lead to glue overflow or wallpaper breakage. |
TIME OF USE | Wallpaper glue has a wet viscosity, that is, tacky when not dry. Generally applied 5-10 minutes when the viscous effect is better, pay attention to grasp the wallpaper paste time. |
PRESERVATION | Please store in a cool, dry place away from light, to avoid long time in the sun under the wallpaper glue exposure. Use up as soon as possible after opening. |