3-Channel Visor Clip Remote Control for 318MHz Linear Megacode Mct-3 318MHz DNT00089
Please Read These Notice Before Purchase:
This remote is an aftermarket replacement remote, NOT a universal one, and it ONLY work for 318MHz Megacode receivers . Or match with theses following model numbers:
Linear s: LDCO852, LDCO850, LDCO800, LSO50, LDO50, LDO33 and LCO75
Linear MegaCode Radio Receivers: MDR/U, MDR, MDR-2, MDRG, MDRM, MGR, MGR-2, SMDRG, AP-4, AP-5 (in none block code mode)
Replacement Remote Control: Linear Megacode MCT-3 DNT00089 ACT-31B ACP00879 MCT-11 DNT00090.
Important Note:Not support dip switch or other brand ! And this remote has no code switches, so it has to be programmed to the radio receiver or .
3 Steps to Set up the Remote
Step 1. Locate the receiver and push the learn button on the . Light will blink.
Step 2. Press any button on the remote that you wish to program.
Step 3. Light on will stop blinking, the remote now is programmed.
*Follow these same steps to program multiple s to this 3 button remote.
Product Details:
1. Number of Buttons: 3
2. Frequency: 318 MHz MegaCode
3. Not original: Replacement aftermarket remote
4. Controls up to 3 Linear or gate s
5. Compatibility: Linear Megacode receivers 318MHz only
6. Programming to Radio receiver or
7. In the Box: 2* 3V 2016 coin-cell batteries (installed), 2*Programming manual, 2*Visor clip, 2*Remote